Is there a step by step guide for setting up a Dm500 with a motor. I.e..a way of knowing what sat i am on, may sound a bit stupid but i can't seem to get a lock on a satellite, i get as far as a valid transponder but iv'e no idea what sat i am scanning, and once scanned it turns up nothing. Tried following the manual i.e..add sats and save, then goto but most of the time it just says moving to 19.2 but don't do anything, or moves in the wrong direction (go's west instead of east) and have to reset to factory to get rid of the message. I know this is basic stuff, am i missing something along the way. It would be nice to just put in co-ordinates for a sat and be able to send it there. Will try again tommorrow but any assist would be helpful.
↧